Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switch configuration - Cisco 8945

Hello cisco community, I'm writing these lines because a issue with a Cisco 8945 Phone. At the beginning the phone was plugged on a Switch 3550 POE and it was working perfectly, but recently the 3550 was changed with a 3560X, after that change, the phone never turn up.

Is there any command in the switch 3560X that I should use to turn up the 8945 Phone?

P.D.: The 3550 was replaced by 3560X because a energy fault (3550 is broken now)

  • LAN Switching and Routing
4 REPLIES
VIP Super Bronze

Switch configuration - Cisco 8945

Is the new 3560X POE?  What is the part number?

If it is POE, there is no need to turn on any command for Phones to work.

HTH

New Member

Switch configuration - Cisco 8945

Hi,

Well, the switch model is WS-C3560X-24P-S, but, how did I say before, the phone does not turn up instead of the switch change

Thanks

Purple

Switch configuration - Cisco 8945

Hi,

have you tried on another port ?

Can you provide sh int status x/x  and sh power inline detail as well as sh int x/x switchport where x/x is the interface where it is connected.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Hall of Fame Super Gold

Switch configuration - Cisco 8945

Hi Eduardo,

Can you please post the following command output from the new switch:

1.  sh version;

2.  sh power inline;

3.  sh interface status err; and

4.  sh interface

185
Views
0
Helpful
4
Replies
This widget could not be displayed.