Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switch configuration urgent help (edge and core)

hi

i have new project in with the bellow product :

 

20 X WS-C2960-24TC-S

 

2 X WS-C3750X-48T-S

 

2 X WS-C2960S-24TS-S

 

i need to configure this switch in order to work without having vlan, first the 2 core switch for redundancy, then each catalyst switch 2960(edge Switch) connected to the two core with 2 uplink each uplink will be connected to single core switch(i have 2 core switch and i want to configure it in stack mode redundancy) 

 

i need help to configure this switch to work perfectly with each other in best redundancy mode any configuration for this switch will be very helpfull for me

thank you

2 REPLIES

Hey,This is a very open

Hey,

This is a very open question but i believe the document below is a good point to start:

http://www.cisco.com/c/dam/en/us/td/docs/solutions/Enterprise/Small_Enterprise_Design_Profile/chap2sba.pdf

HTH.

Regards,

RS.

New Member

i just need to configure the

i just need to configure the basic to make the network run only

if any can help me with basic template for edge and core it will be great

76
Views
0
Helpful
2
Replies
CreatePlease to create content