I have a large network with vlan, dtp, trunk, etc. Sniffing traffic on some switch, i found unicast traffic flooded on all ports. I know how catalyst switch work, and there was 2 situation on which this happen
1)Mac address table full
2)Mac address of destination not in list
Ok. But i would like to know if there is a method to avoid this situations.
Can you give me some link that point out this kind of problems?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...