Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Switch Hyper Terminal Problem

when we want to connect switch though Hyper Terminal it showing following problem:-

% No defaulting allowed

Enter interface name used to connect to the management network from the above interface summary:

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Switch Hyper Terminal Problem

Hello Ravi,

the switch has an empty configuration and you are during initial setup where it puts you questions like the one you have reported.

This question asks what of the interfaces with an ip address has to be used to look for a default gateway/default route

you can skip all this and you can manually configure the device or you can take advantage of initial setup to have some parameters configured like hostname, ip addresses on interfaces and where to look for a default gateway/default route

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: Switch Hyper Terminal Problem

Hello Ravi,

the switch has an empty configuration and you are during initial setup where it puts you questions like the one you have reported.

This question asks what of the interfaces with an ip address has to be used to look for a default gateway/default route

you can skip all this and you can manually configure the device or you can take advantage of initial setup to have some parameters configured like hostname, ip addresses on interfaces and where to look for a default gateway/default route

Hope to help

Giuseppe

Community Member

Re: Switch Hyper Terminal Problem

hi qiuslar

thx now i have work it.

1177
Views
0
Helpful
2
Replies
CreatePlease to create content