Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switch management access

Hello,

 

Cisco 3560 configured with management VLan10 ip 10.10.10.10 can be accessed via ssh, add new management interface VLan60 ip 10.10.60.10, also can access via ssh.

 

When I remove interface vlan 10, I can no longer access the switch, ip 10.10.60.10 is reachable, tried transport input to include telnet, same behavior.

 

What am I missing here?

 

Thanks

 


Switch Ports Model              SW Version            SW Image
------ ----- -----              ----------            ----------
*    1 52    WS-C3560-48PS      12.2(53)SE2           C3560-IPBASEK9-M

 

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

BrendanIs this switch meant

Brendan

Is this switch meant to be acting as a L2 switch or a L3 switch ?

If it is L2 then disable ip routing and use the default gateway you have already configured

if it is L3 then remove the default gateway and add a default route using the same next hop IP eg.

ip route 0.0.0.0  0.0.0.0 10.10.60.1

Jon

 

5 REPLIES

HelloWhen you removed this

Hello

When you removed this svi vlan10 is this switch running a a host or l3 router?

do you have an default-gateway configured or ip routing enabled?

 

res

paul

Please don't forget to rate any posts that have been helpful. Thanks.
New Member

Thanks Paul, L3 and both

Thanks Paul,

 

L3 and both default-gateway and ip routing enabled

 

ip default-gateway 10.150.60.1
 

interface Vlan10
 ip address 10.10.10.25 255.255.255.0
!
interface Vlan60
 ip address 10.150.60.25 255.255.255.0

 

Brendan
 

Hall of Fame Super Blue

BrendanWhat device is 10.150

Brendan

What device is 10.150.60.1 ?

Can you post an output of "sh ip route" from the switch ?

Jon

New Member

10.150.60.1 is the core

Should read 10.10.60.1 is the core switch, directly connected by trunk

 

     10.0.0.0/24 is subnetted, 2 subnets
C       10.10.10.0 is directly connected, Vlan10
C       10.10.60.0 is directly connected, Vlan60
 

 

Thanks

Brendan

Hall of Fame Super Blue

BrendanIs this switch meant

Brendan

Is this switch meant to be acting as a L2 switch or a L3 switch ?

If it is L2 then disable ip routing and use the default gateway you have already configured

if it is L3 then remove the default gateway and add a default route using the same next hop IP eg.

ip route 0.0.0.0  0.0.0.0 10.10.60.1

Jon

 

55
Views
0
Helpful
5
Replies