Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Switch not showing the "boot system flash:<imagefilename> statement

This morning while getting ready to upgrade the IOS on a 3560 switch at one of my clients, I was in configuration mode. I have two image files loaded into flash, the old and the upgrade image.

I then tried to add the "boot system flash:<imagefile> command to the configuration. The switch accepts the command, but thereafter when I perform a "sho run | i boot, the boot system flash statement is not in the configuration.

I also looked doing a full show run. The boot system flash statement is simply not there.

Has anyone observed this behavior before. Thanks for any guidance.

1 REPLY

Re: Switch not showing the "boot system flash:<imagefilename> st

It's normal behavior.

"sh boot" will show you the boot image info, but not sh start | inc boot.

HTH

Sam

140
Views
0
Helpful
1
Replies
CreatePlease to create content