Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch Not Usable

I am having some problems with a switch that i have. It happened after a power outage but the switch is plugged into a UPS. i have pasted the info below.

Restricted Rights

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C3750 Software (C3750-I9-M), Version 12.

2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Tue 03-Feb-04 09:20 by yenanh

Image text-base: 0x00003000, data-base: 0x007C887C

Initializing flashfs...

flashfs[1]: 80 files, 4 directories

flashfs[1]: 0 orphaned files, 0 orphaned directories

flashfs[1]: Total bytes: 15998976

flashfs[1]: Bytes used: 6479872

flashfs[1]: Bytes available: 9519104

flashfs[1]: flashfs fsck took 8 seconds.

flashfs[1]: Initialization complete....done Initializing flashfs.

POST: CPU MIC register Tests : Begin

POST: CPU MIC register Tests : End, Status Passed

POST: PortASIC Memory Tests : Begin

POST: PortASIC Memory Tests : End, Status Passed

POST: CPU MIC PortASIC interface Loopback Tests : Begin

POST: CPU MIC PortASIC interface Loopback Tests : End, Status Passed

POST: PortASIC RingLoopback Tests : Begin

POST: PortASIC RingLoopback Tests : End, Status Passed

POST: Inline Power Controller Tests : Begin

POST: Inline Power Controller Tests : End, Status Failed

POST: inline power controller test failed

driver class subsystem initialization failed

cisco WS-C3750-48P (PowerPC405) processor (revision B0) with 118776K/12288K byte

s of memory.

Processor board ID CAT0826R08M

Last reset from power-on

The password-recovery mechanism is enabled.

!!! WARNING: The switch is not usable !!!

Unable to create l2trace server process, socket_open() failed

Press RETURN to get started!

1 REPLY
Cisco Employee

Re: Switch Not Usable

Its a hardware failure on the switch. The power on self test has failed the Inline power controller test. This inline power controller hardware has failed.

Please open a TAC case and request an RMA for the same.

HTH,Please rate if it does.

-amit singh

351
Views
0
Helpful
1
Replies
CreatePlease to create content