Hi there,
I have a Cisco 3020 bladeswitch that is only reporting interface bandwidth of 10000Kbit when the link is actually a gigabit interface:
GigabitEthernet0/9 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 001b.0c06.4909 (bia 001b.0c06.4909)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 21/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed, link type is auto, media type is 1000BaseX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:29:44
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 844000 bits/sec, 54 packets/sec
5 minute output rate 13000 bits/sec, 37 packets/sec
179197 packets input, 243202451 bytes, 0 no buffer
Received 42 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
134878 packets output, 9565053 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Here's the interface configuration:
Current configuration : 60 bytes
!
interface GigabitEthernet0/9
spanning-tree portfast
end
I've tried having both sides as Auto, and both sides set manually, with no luck. Has anyone seen this issue before? Any ideas?
Thanks in advance
