I've got two SG300 Switches running in a customer's network. The connected ports' LEDs blink green indicating traffic, but every 3 - 4 seconds all LEDs stop blinking and simutlaneously turn solid green for about a second - then they proceed to blink as usual.
Is this normal or does the short solid green phase indicate some kind of problem? Unfortunately I couldn't find any useful information on LED states in the administration guides/data sheets.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...