How do we check that how long period that a switch port is in a notconnect status? Like for example, in Cisco IOS 4506 we can use "show int link" command to show the port link status. But how do we do that in older switch model such as 2950,3550,3560 and 4948? And also how to check this info in the Catalyst switch runnning CatOS image file? Thanks
But why when i run "show int" command in the WS-C3560-48PS switch, it shows this Last input never, output never, output hang never. What does this line means?
cisco WS-C3560-48PS (PowerPC405) processor (revision N0) with 118784K/12280K byt es of memory. Processor board ID FDO1127Y0RH
KM52A-BAS01>show int f0/7 FastEthernet0/7 is down, line protocol is down (notconnect) Hardware is Fast Ethernet, address is 001c.58ce.9209 (bia 001c.58ce.9209) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex, 100Mb/s, media type is 10/100BaseTX input flow-control is off, output flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never Last clearing of "show interface" counters 22w6d Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts (0 multicast)
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...