CSCef87815 in which you can verify by doing the following:
1. reset the line card and see if the error stops and you are able to connect and device that draws power from the line card.
2. By capturing the output of "show plat chassis int gig1/1" about 3 times with about 1 minute gap see if it will show an increment in the errCount_ for GalJerryMan and DpmMan.
If those counters increment you are hitting this bug and shoudl replace the line card.
The second bug is CSCsf26804 in which you maybe also reset which should recover the line card. The second bug states that a s/w fix is integrated in The software workaround is integrated to to 12.2(31)SGA2 and 12.2(25)EWA10. you are running 12.2(25)SG which is below 12.2(31)SGA2 which makes the code your switch is running susceptible to this bug.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...