Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switch ports

Hi,

I observed that some of the unused ports on 65xx switches have amber lights even if there's no cables connected to the port. Is this an issue ?

Your inputs please.

k0rg

5 REPLIES
Cisco Employee

Re: switch ports

Was there once devices plugged here?

Usually amber means:

1. the port is errdisable

2. the port is in spanning tree blocking state

3. there is some other kind of error

The thing to do is write down those port numbers and check the 'show log' command for any syslogs related to those ports.

Also check 'show interface gx/y' for those ports to see what state they are in (possibly error disabled)

My best guess, is that at one point stuff was attached here, they did something to error disable the port, they moved to a new port and left that port in an error disable state.

The easy way to get out of error disable is to either shut/no shut the port.

New Member

Re: switch ports

I dont think these ports were used before. Is there any other cause ? Thanks.

New Member

Re: switch ports

Hi Jose,

It is perfectly fine no need to worry about that .

Chao

Vishwa

New Member

Re: switch ports

Hi

This is the default behaviour of 65XX switches.

The indication you mentioned tells that the ports are enabled. By default all the ports are in shutdown state and L3 mode. If you enable the port it indicates you with amber.

donot worry about this behaviour.

regards,

R.B.Kumar

New Member

Re: switch ports

Many thanks to all your replies. Cheers !

113
Views
0
Helpful
5
Replies