The "show controllers utilization" command shows only the instantaneous load on the switch or specific ports. You may just try to use the combination of the following commands to get the statistics for the ports:
many thanks for the answer, this helps interpret the numbers. However, I hardly believe that a switch aggregating the traffic of 8 servers and nearly 100 workstations, running RSTP and a lot of processes can work with zero utilization - even instataneous, can yo ? This is a fairytale.
I rather think this is another nice lying feature of the CLI (just like qos policy-map interface counters).
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...