03-26-2007 07:33 AM - edited 03-05-2019 03:05 PM
Hi,
Is it possible to add some commands to improve VMWARE server connected to Cisco Switches.
The VMWARE Servers use the same card for whole servers on them.
regards,
03-26-2007 07:47 AM
Hello,
Which switch is this ?
You can enable spanning-tree portfast on the the switchports connected to the server. Disable DTP/PAGP negotiations on the ports connected to the server.You can haddcode the speed/duplex on the ports and the serverside if you have any speed/duplex issues.
HTH,
-amit singh
03-27-2007 12:12 AM
Switches are 2960. The configuration seems to be like you specified. I would like to know if there were specific command thant can be added for VMWARE.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: