Hi, I have a new fiber connection to close my network, but when I tray to connect my Build 3 switch with my Build 2 switch, it does a loop and I need to unplug the fiber, this is the configuration on that ports
Ummmm ... You really are not providing much information. From the diagram, the 3560CG has another link going to another switch (upper right-hand corner and down to another one above your 4503). So I really can't make any comment until we know what the config of those two boxes are.
If you are so much concerned about the loop, which rightly you should, then you may have to consider temporarily disabling one of the two links.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.