Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switching method

I have cisco switch 2960-24TC

the default cisco switch work as store and forward , how can tell the switch to work as cut-through

thanks

4 REPLIES
New Member

Re: switching method

Don't think you can do this I'm afraid as it is in the nature of the ASICs imho. Apparently there may be a resurgence of cut-through switching through enhanced ASICs but I believe it's only store-and-forward at present.

HTH

New Member

Re: switching method

Hello Friend,

If you want to use cut-through mode between interfaces within the same bridge group, use the cut-through command in interface configuration mode. To return to store-and-forward mode just use no form of this command.

Syntax:

cut-through [receive | transmit]

no cut-through

receive - (Optional) Selects cut-through switching technology on received data

transmit - (Optional) Selects cut-through switching technology on transmitted data

Example config:

SW(config)# interface fastethernet 3/0

SW(config-if)# bridge-group 10

SW(config-if)# cut-through

SW(config-if)# no shutdown

SW(config-if)# exit

SW(config)#

That's all!  Any other question? Hope will be helpful:)

Regards,

S.Vusal

New Member

Re: switching method

I think Cisco IOS version 12.2 or above should support this.

2203
Views
0
Helpful
4
Replies
CreatePlease login to create content