Having an issue setting up a switch for NEC ip phones. If I use something like this:
int gi 0/23
description Phone and PC, no hubs
switchport mode access
switchport access vlan 10
switchport access voice vlan 5
The phones boot up fine, but get ips from the dhcp pool for vlan 10. My pc behind that also gets an ip in vlan 10. I went to a test phone and enable cdp and when I went back to my switch I saw the phone in cdp neighbors, but the phone still grabbed the ip from the other vlan. If I manually key in the vlan on the phone it gets the correct ip and the pc behind it gets the correct ip as well. Just wondering if there is a better to go about this as they are deploying 150 phones.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...