Hi, I have a webfilter server that I have set up out of band. In previous installs I've always had the server connected to a the same switch that my firewall was comming in on.
However this time the server is located on another access switch. I'm having issues configuring or how I should configure the SPAN port. Since the source port that I'm monitoring is not on the same switch as the destination port I'm unsure if I should source the Vlan that its comming in on or the trunk port its comming in on or if there is another method. Here's what I added to the access switch that is attached to the server:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...