Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switchport voice vlan

Example:

interface fa0/1

switchport access vlan 10

switchport voice vlan 510

As far as I know, when we try this configuration your voice and vlan data are being carried on separate vlans. Also I have notice that when we perform a:

switch# show vlan

the swtichport shows up on both vlans (10 and 510). However, this normal behavior does not happen on a ws-c2924-xl switch. This switch model does have the commands available ("switchport voice vlan") but does not seem to put the port on both vlans. What I need the switch to do is tagged the voice traffic and leave data traffic untagged.

Am I wrong??

2 REPLIES

Re: switchport voice vlan

Cisco negotiates a speciallized dot1q trunk when you use the voice vlan command and tags the voice vlan traffic and native vlan traffi as untagged

Since the XL series switches are pretty old, these might be shown on the trunk port

HTH

Narayan

Silver

Re: switchport voice vlan

Also, IP phone might have to present for VLAN to be up on that switch. For some purposes Cisco uses CDPv2 to detect IP Phone

410
Views
0
Helpful
2
Replies