You need to give the command "logging trap 6". 6 stands for Informational messages. Interface up or down transitions and system restart messages, displayed at the notifications level. Reload requests and low-process stack messages, displayed at the informational level. This message is only for information; switch functionality is not affected. Level 7 is debugging. But if this is enabled, then you will receive lot of messages and it can also affect the performace of the switch, so it is recommened to stick to level 6.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...