i have a problem with my 1841ISR and my Catalyst 3500xl switch... I have currently configured a kiwi syslog server but it seems that only my PIX firewall is the one sending out debugging logs and my switch and router isn't.
below is my switch config:
no service pad
no service timestamps debug uptime
no service timestamps log uptime
ate to u
ip default-gateway 192.168.32.1
logging trap debugging
logging facility local5
logging source-interface VLAN1
and for my router I do see syslog messages on my kiwi but only this type of logs:
2007-09-20 16:38:35 Local7.Info 192.168.100.1 169: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 192.168.100.21 started ? reconnection
2007-09-20 16:38:35 Local7.Notice 192.168.100.1 168: %SYS-5-CONFIG_I: Configured from console by admin on vty0 (192.168.100.88)
Hi, Looks like the router is able to send the logs to the syslog server just fine. I am not sure, what is it that you are missing? Are there any additional logs that you can see in the 'show log' output on the router but not on the syslog server? If not, I think the router is logging just fine.
For the switch -
Is the syslog server connected to a port in Vlan3 as well?
Are you able to ping it from the syslog server from the switch?
Are there any intermediate devices between the switch and the syslog server?
Remove 'logging source-interface Vlan3' and see if that helps.
Is the switch connected directly to the syslog server? If not, can you check if udp port 514 is allowed (if there's a firewall in between)?
If all's okay, the best thing to do is span the port on the switch which connects to the syslog server and capture sniffer trace. If the sniffer shows syslog messages leaving the switch, the problem is not with the switch.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.