cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2389
Views
0
Helpful
5
Replies

TACACS configuration in Cisco 6509

Anand Narayana
Level 6
Level 6

Hi,

i wanted an equivalent command for configuring in Cisco 6509 running Cat OS.

i know Catalyst OS to Cisco IOS configuration converter is there, but i am looking for Cisco IOS to Catalyst OS configuration converter? can any one help me in this regard.

looking for a equal command for the following

aaa new-model

aaa authentication login default group tacacs+ enable local

aaa authentication enable default group tacacs+ enable

aaa authorization exec default group tacacs+ if-authenticated

aaa authorization commands 1 default group tacacs+ if-authenticated

aaa authorization commands 15 default group tacacs+ if-authenticated

aaa accounting exec default start-stop group tacacs+

aaa accounting commands 1 default start-stop group tacacs+

aaa accounting commands 15 default start-stop group tacacs+

tacacs-server host 10.203.1.92 key checkingtheswitch.

since it is a Cisco 6509 production switch, i don't want to take chance, as there is a possibility that i might not login if the configuration is incorrect.because i faced similar situation when i implemented in Cisco IOS in the initial stage in one of the edge switch.later i have reset the switch & finally could implement with the working config as mentioned above.

1 Accepted Solution

Accepted Solutions

Amit Singh
Cisco Employee
Cisco Employee
5 Replies 5

Hi a good tip,

Try to set up another switch ... and test this first

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

Amit Singh
Cisco Employee
Cisco Employee

Hi Anand,

Please use the link below for more info.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_1/confg_gd/authent.htm

-amit singh

Thanks Amit,

This document was very useful contains more informations about AAA than what i was looking in for.

did you ever get an answer on the config? I have a 6500 setup but enable does not work correctly

What exactly is happening. Here are the cat os commands for aaa,

onsole> (enable) set tacacs server [IP] [primary]

set tacacs key [key]

set tacacs attempts [number] (optional)

set localuser user [user] password [password] privilege 15

set authentication login local enable

set authentication login tacacs enable [all | console | http | telnet] [primary]

set authorization exec enable tacacs+ [deny | none] [console | telnet | both]

set authorization commands enable [config | all] tacacs+ [deny | none] [console |

telnet | both]

Regards,

~JG

Please rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: