07-09-2008 05:32 PM - edited 03-06-2019 12:06 AM
I saw this configuration in one of our switch port, but nobody knows why?
!
interface FastEthernet0/43
switchport access vlan 2
switchport trunk encapsulation dot1q
switchport mode trunk
speed 100
duplex full
no cdp enable
end
As far as we know it works as a trunk port, but is there any difference that this could make?
Regards
vsubbu
07-09-2008 05:46 PM
Hi Vsubbu,
It is a trunk port . "switchport access vlan 2" will not make any difference.
HTH
Saju
07-09-2008 07:14 PM
Usually, the 'access vlan' is entered as a fall-back Vlan in case the trunk fails for some unknown reason.
On this case, you stated the trunk is functional, therefore the command isn't doing anything.
HTH,
__
Edison.
07-10-2008 07:55 AM
Saju & Edison,
Thanks for your comments.
Rgds
vsubbu
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: