Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

telnet connection refused to terminal server router

I have a terminal server router of which cable number 4 and 5 i have connected to my PC at the serial port. however when try to do telnet iam not able to get the console.

when i try to do telnet 10.201.200.15 2035 it return an error connection refused

here is my configuration file

****************** configuration ***

version 12.3

service timestamps debug datetime msec

service timestamps log datetime msec

no service password-encryption

!

hostname ts-cluster-c

!

boot-start-marker

boot-end-marker

!

enable secret 5 $1$V5Nu$RGD3V1a3dJyh4Q6/7NFtH1

enable password eskimo66

!

no network-clock-participate slot 1

no network-clock-participate wic 0

no aaa new-model

ip subnet-zero

no ip routing

no ip cef

!

!

!

no ftp-server write-enable

!

!

!

!

interface FastEthernet0/0

ip address 10.201.200.15 255.255.255.0

no ip route-cache

duplex auto

speed auto

no mop enabled

!

interface Group-Async0

physical-layer async

no ip address

no group-range

!

ip default-gateway 10.201.200.1

ip classless

ip http server

!

!

line con 0

line 33 48

line aux 0

line vty 0 4

password cisco

login

!

!

!

end

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions

Re: telnet connection refused to terminal server router

Hi,

You need the following:

under the async interface:

--> physical-layer async

--> async mode interactive

under the async TTY line(s) (33-48):

--> transport input telnet

--> stopbits 1

Plus make sure that the interface you are using its ip for the reverse telnet is up/up, and its recommended to use a loopback interface for this issue.

HTH, please rate if it does help,

Mohammed Mahmoud.

1 REPLY

Re: telnet connection refused to terminal server router

Hi,

You need the following:

under the async interface:

--> physical-layer async

--> async mode interactive

under the async TTY line(s) (33-48):

--> transport input telnet

--> stopbits 1

Plus make sure that the interface you are using its ip for the reverse telnet is up/up, and its recommended to use a loopback interface for this issue.

HTH, please rate if it does help,

Mohammed Mahmoud.

1449
Views
0
Helpful
1
Replies
This widget could not be displayed.