Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Telnet from outside switch using uplink ports

Just got a Catalyst 2960 installed.

The problem I have is that when I am connected to Fa0/1 to Fa0/24 I can get to telnet and ping the switch just fine.

Now if I run a cable between a second switch (Allied Telesyn) and one of the Fa0/1 to Fa0/24 ports I can ping switch and use telent.

Now if I use on of the ports uplink Gi0/1 or Gi0/2 nothing on the telnet or ping front. I can see devices on the switch just fine. So traffic is moving.

What have I done wrong or not done?

3 REPLIES
Silver

Re: Telnet from outside switch using uplink ports

Hi,

Not sure of your topology, but is the gig 0/1 or 0/2 ports either configured as static access for the vlan or as trunk port?

HTH

LR

New Member

Re: Telnet from outside switch using uplink ports

Hi

Well being a newbie, I just ended up trying the CNA and that fixed it for me.

New Member

Re: Telnet from outside switch using uplink ports

Copy of Config

114
Views
0
Helpful
3
Replies
CreatePlease login to create content