10-08-2008 06:48 PM - edited 03-06-2019 01:50 AM
I have a cisco 2960 switch.
I can ping this switch without any loss.
No issue in connectivity. when the telnet command is issued it telnets the switch and ask the telnet password. But when I am typing the password i get disconnected automatically.
Please help to solve this.
10-08-2008 11:54 PM
Do you have the basic telnet config
2960#config t
2960(config)#line vty 0 4
2960(config-line)#password xxxxx
2960(config-line)#login
If its there make sure that there isnt any device using the same ip as switch
Syed
10-09-2008 03:18 AM
While you are at it set your enable secret password also .
10-10-2008 03:52 AM
I think it's problem related to ip conflict
Please check the change the switch ip and check again
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide