08-13-2013 04:09 AM - edited 03-07-2019 02:53 PM
I am having cisco 3750 switch, after config line vty (Telnet) in four stack all are working fine only one stack telnet is not working.
i am able to ping Mgmt vlan IP.
Switch telnet config is ....
username cisco privilege 15 password 0 cisco
vlan 1521
name MGMT_VLAN
Int vlan 1521
ip add 192.168.10.10 255.255.255.0
line con 0
password cisco
login local
line vty 0 4
exec-timeout 0 0
password cisco
login local
line vty 5 15
exec-timeout 0 0
password cisco
login local
I have tryed to remove exec-timeout command
type "no exec-timeout" ( but unable to remove, after "save" type "show run" again exec-timeout 0 0 comes under line vty, even i have changed exec-timeout 3 0 but no luck )
08-13-2013 04:24 AM
Hi,
exec-timeout 0 0 and no exec-timeout have the same effect that is your sessions won't timeout under the lines.
It shouldn't prohibit you from telnetting into the device now if you issued no exec then you disabled access to the line( but it would show as no exec in the show run).
Regards
Alain
Don't forget to rate helpful posts.
08-13-2013 11:22 AM
so what could be the solution for this, i have given switch config related to telnet.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: