Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Tera Term weird message

Hi, 

 

I was connecting to a switch in my home lab via Tera Term, and I keep getting these weird messages, any idea what the problem is? Attached is a screenshot of the error messages I keep getting.

 

Thanks for your help!!!

1 REPLY
Community Member

The first guess would be a

The first guess would be a baud-rate problem with either Teraterm or the UART being set to different baud rates,or something has changed in the CPU clocking.

You say the receiver is working. Is it receiving the correct characters?

Can you send characters one at a time by dumping them (from the debugger) into the transmitter?

Check 7/8/9 data bits, parity off/on/odd/even and the numbr of stop bits.

The best thing to do is to see what is being transmitted with an oscilloscope, then measure the bit times and the transmitted data format.

118
Views
0
Helpful
1
Replies
CreatePlease to create content