Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Terminal Server connectivity

Hi,

I am implementing Terminal Server connectivity for DC.

4 of my devices are far than the distance of 200 mts. So I have connected the device to terminal server by following method.

 

Terminal Server(RJ45) -----> (RJ45)Media Converter ----------------(Fiber cable)----------------------------Media Converter(RJ45)----------Con 0 (Device)

 

After configuring the Terminal server, i am able to access other devices except these 4 devices which are connected via Media Converter.

Can someone please help resolving this issue.

 

Regards,

Mon

1 REPLY

I have not attempted this

I have not attempted this setup before, but it's unlikely it will ever work. Since the console port uses a rollover cable and not a standard cat5/5e/6 cable. The fiber converter is going to convert the electrical signal to optical based on Ethernet standards, thus rendering this setup unusable. Hope that helps. Regards, Mike
23
Views
0
Helpful
1
Replies