Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Terminating Q-in-Q on WS-C3750G-24TS-S1U

Hello,

we have a connection from a service provider between location A and B where in location A i have an ethernet port and i configure a switch interface as trunk with 802.1q encapsulation and i try to pass vlans 421-423. in location B the ethernet is presented in the form of a Q-in-Q trunk. So from what i understand the vlans i put in the trunk in location A are encapsulated inside what the service provider called svlan with the id 10. i have the following configuration of the ethernet port in location B:

 

interface GigabitEthernet2/0/25
 description Eircom_Fibre
 switchport access vlan 10
 switchport trunk encapsulation dot1q
 switchport mode dot1q-tunnel
 l2protocol-tunnel cdp
 l2protocol-tunnel stp
 l2protocol-tunnel vtp
 no cdp enable

 

now i was hoping i could simply configure another interface as .1q trunk and pass traffic on via a normal trunk instead of Q-in-Q. the interface for that is configured as follows:

 

interface GigabitEthernet2/0/1
 description Ceragon Payload
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 421,422
 switchport mode trunk

 

unfortunately i can not pass traffic. it seems the switch is not picking the vlans out of the svlan with the id 10. can anybody advise how i can access the vlans from within the q-in-q trunk ?

Kind Regards

Jan

48
Views
0
Helpful
0
Replies
CreatePlease to create content