I have a 100BaseT Ethernet Router to Ethernet Router link over several miles of fiber using TCP/IP with fixed IP addresses. Nothing in between except fiber and electrical to optical conversion.
What test equipment is recommended to measure Bit Error Rate from Ethernet port on one end to Ethernet Port on the other end? Im used to using paired PRBS generator/receiver gear to measure BER on serial links (such as Fireberd 6000a), but how is this done on a packet based link? Is there other equipment that might provide BER or other measurements of link quality for this point to point link?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...