01-23-2009 10:36 AM - edited 03-06-2019 03:37 AM
is there a way to see where the traffic will go on cat 4948 in the etherchannel.
i could not find test etherchannel load-balance command.
Solved! Go to Solution.
01-23-2009 11:54 AM
Hi, here is what you are looking:
show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y
Switch#show platform software etherchannel port-channel 1 ?
map Map given parameters to a port in the channel
| Output modifiers
Switch#show platform software etherchannel port-channel 1 map ?
ip Ip address
l4-port TCP/UDP port numbers
mac Mac address
Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?
% Unrecognized command
Switch#show platform software etherchannel port-channel 1 map ip ?
A.B.C.D Source/Destination Ip address
Switch#show platform software etherchannel port-channel 1 map ip
01-23-2009 11:54 AM
Hi, here is what you are looking:
show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y
Switch#show platform software etherchannel port-channel 1 ?
map Map given parameters to a port in the channel
| Output modifiers
Switch#show platform software etherchannel port-channel 1 map ?
ip Ip address
l4-port TCP/UDP port numbers
mac Mac address
Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?
% Unrecognized command
Switch#show platform software etherchannel port-channel 1 map ip ?
A.B.C.D Source/Destination Ip address
Switch#show platform software etherchannel port-channel 1 map ip
01-23-2009 12:04 PM
awesome
you are the man
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide