I have been testing 2610 and 2611 routers (The only connection is through console port and ethernet to the TFTP server). The routers recognize all the Ethernet and WAN interfaces. The ethernet LED is OK but the WAN cards LED are off as there are unconnected.I have configured the interfaces of these WAN cards(A BRI port and SERIAL port) with IP address, when i use the command Show interface i can see all the interfaces are UP and line protocol is UP. Is this enough to testify that the WAN cards are GOOD or is there any other technical way to test these modules. Does it need to connect all these WAN cards and PING them or is there a command which will be enough to prove that the WAN cards are all GOOD and not FAULTY.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...