Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

TFTP Interface

Dear all,

is it possible to "say" a multilayer swtich (3750) which interface he should use for a tftp upload? With ping and trace I can, but is it for tftp for example also possible?

It would be helpfull for our firewall configuration on remote locations.

Thanks in advance

Sebastian

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: TFTP Interface

Hello Sebastian,

the interface on the path to destination is chosen normally.

to have a consistent behaviour you should use something like

ip tftp source-interface vlan10

in global config

Hope to help

Giuseppe

Silver

Re: TFTP Interface

Hi,

yes you can specify this by using following command using lo0:

ip tftp source-interface Loopback0

HTH,

Dario

5 REPLIES
Hall of Fame Super Silver

Re: TFTP Interface

Hello Sebastian,

the interface on the path to destination is chosen normally.

to have a consistent behaviour you should use something like

ip tftp source-interface vlan10

in global config

Hope to help

Giuseppe

Silver

Re: TFTP Interface

Hi,

yes you can specify this by using following command using lo0:

ip tftp source-interface Loopback0

HTH,

Dario

Re: TFTP Interface

Hey Guiseppe, Dario,

Thanks a lot for the fast replies, very easy and I didn't find it in the conf guide...

Best regards,

Sebastian

Silver

Re: TFTP Interface

Re: TFTP Interface

Great Dario....Thank's..

170
Views
10
Helpful
5
Replies
CreatePlease to create content