Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

The Cisco 7609 can't display the running-configuration

I haver Cisco 7609 with sup720. Today, I find it can't display the running-configuration, when I execute the "show run" command ,it stop there about 10 minutes,and responds with "Unable to get configuration. Try again later."

Any help?

Thanks.

------- show running-config ----------

Unable to get configuration. Try again later.

------------------ show version ------------------

Cisco IOS Software, c7600s72033_rp Software (c7600s72033_rp-IPSERVICES-M), Version 12.2(33)SRB2, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Wed 10-Oct-07 13:47 by prod_rel_team

ROM: System Bootstrap, Version 12.2(17r)S4, RELEASE SOFTWARE (fc1)

ZBFJ-HX-CISCO7609 uptime is 2 weeks, 5 days, 22 hours, 59 minutes

Uptime for this control processor is 2 weeks, 5 days, 23 hours, 3 minutes

Time since ZBFJ-HX-CISCO7609 switched to active is 2 weeks, 5 days, 23 hours, 2 minutes

System returned to ROM by power cycle (SP by power on)

System restarted at 13:14:32 beijing Tue Oct 20 2009

System image file is "bootdisk:c7600s72033-ipservices-mz.122-33.SRB2.bin"

Last reload type: Normal Reload

cisco CISCO7609 (R7000) processor (revision 1.2) with 458720K/65536K bytes of memory.

Processor board ID FOX1222G3Z7

SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache

Last reset from s/w reset

45 Virtual Ethernet interfaces

100 Gigabit Ethernet interfaces

1917K bytes of non-volatile configuration memory.

8192K bytes of packet buffer memory.

65536K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102

1 REPLY
Hall of Fame Super Silver

Re: The Cisco 7609 can't display the running-configuration

Hello Xiaojun,

this can be related to a SW bug.

I remember other threads about this.

can you enter config mode?

I would consider upgrading IOS image

to 12.2(33)SRD2

Hope to help

Giuseppe

694
Views
0
Helpful
1
Replies
CreatePlease to create content