Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

the pattern of replacing 4506 (when it goes wrong)

Hello.

We have to make the manuals how to install IOS or to input configuration to the Catalyst 4506 machine.

And, especially we don't know how many patterns there are about it.

①Supervisor

Of course,in this pattern the configuration may be not kept.

We have to install IOS or to input configuration,don't we?

②IF module(such as WS-X478-RJ45-E)

③Power supply

 I think that ,in these cases, we don't need to do any more. Is it true?

 Only by installing the module, the machine will operate as it did, I assume.

Regards,

spitz1995

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Refer this page and find the

Refer this page and find the configuration guide that matches software version you use in your 4506

http://www.cisco.com/c/en/us/support/switches/catalyst-4500-series-switches/products-installation-and-configuration-guides-list.html

HTH

Rasika

*** Pls rate all useful responses ***

2 REPLIES
VIP Purple

Refer this page and find the

Refer this page and find the configuration guide that matches software version you use in your 4506

http://www.cisco.com/c/en/us/support/switches/catalyst-4500-series-switches/products-installation-and-configuration-guides-list.html

HTH

Rasika

*** Pls rate all useful responses ***

New Member

Thanks for your answer.

Thanks for your answer.

We'll make the manuals as we follow the page.

23
Views
0
Helpful
2
Replies
CreatePlease to create content