The tunnel interface is down due to recursive routing.
Please explain me in details.
Tunnel interface is down due to recursive routing because tunnel destination IP learned by Tunnel interface itself. But I do not understand Why It is getting down after learned the tunnel destination IP address. Please explain in details>
Gateway of last resort is not set
184.108.40.206/24 is subnetted, 1 subnets
C 220.127.116.11 is directly connected, Loopback1
18.104.22.168/24 is subnetted, 1 subnets
R 22.214.171.124 [120/1] via 192.168.1.2, 00:00:05, Tunnel1
126.96.36.199/24 is subnetted, 1 subnets
R 188.8.131.52 [120/1] via 192.168.1.2, 00:00:05, Tunnel1
[120/1] via 10.1.1.2, 00:00:18, FastEthernet0/0
10.0.0.0/24 is subnetted, 1 subnets
C 10.1.1.0 is directly connected, FastEthernet0/0
C 192.168.1.0/24 is directly connected, Tunnel1
*Mar 1 00:21:53.051: %TUN-5-RECURDOWN: Tunnel1 temporarily disabled due to recursive routing
*Mar 1 00:21:54.051: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel1, changed state to down
Re:The tunnel interface is down due to recursive routing.
To.establish the tunnel it requires a source and destination.address to be reachable via the physical links learnt via either static or dynamic routing process. (igp)
When your tunnel is established its source and destination address should not be advertised over.these tunnel interfaces - as these tunnels are only virtual interfaces created to run.over the physical.path
So if these tunnels see a better preffered path over it.virtual link for its destination addresses lt would result in the error you are.receiving.
Sent from Cisco Technical Support Android App
Please don't forget to rate any posts that have been helpful.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...