Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Three tier architecture configuration

Hi,

We wanted to configure the network attached.

We wanted to know how best we can configure access layer switches, distribution switches & Core switches.

Access switch is 3750 PoE,distribution is 4506 & Core is 6513

We are planning to use static routing within the campus & OSPF across WAN.

If you have any configuration examples it would have been very helpful.

Thanks.

Rgds.,

Sack

2 REPLIES
Cisco Employee

Re: Three tier architecture configuration

Sachin,

Have a look at the "Cisco Validated Design" from the below URL for detail drawings and configuration information on Campus, Data Center, etc, designs. This should assist you in coming up with an optimal design.

http://www.cisco.com/en/US/netsol/ns741/networking_solutions_program_home.html

Regards,

Arul

** Please rate all helpful posts **

Bronze

Re: Three tier architecture configuration

Arul's suggestion is right on. To add I suggest looking at the High Availability Campus Network Design-Routed Access Layer using EIGRP or OSPF. I've always thouhgt this design provides the quickest convergence, fault-tolerance, and most efficient load-sharing for a campus network.

1540
Views
0
Helpful
2
Replies