Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Throughput on a 5505

I have a 5505 with SUP3 and 24 10/100 blade , FE-TX blade and gigabit uplink module.

The best throughput I get is 45Mbits/s in the same blade. It traffic goes through the uplink module throughput drops to 25Mbits/s. Is it normal? I have two unit and they both performs the same. Tested with foundry and summit and got 80Mbits/s+ with the same stations.

2 REPLIES
Purple

Re: Throughput on a 5505

This is a very old switch circa 1997 and I believe total backplane capacity is only 1 gig so most likely you are oversubscribed and what you are seeing is normal.

New Member

Re: Throughput on a 5505

Nope, I actually found out what the problem was. Just duplex mismatch! Throughput now is 11Mbytes/s!

196
Views
0
Helpful
2
Replies
CreatePlease login to create content