I have got two networks. Lets say 10.5.85 n/w and 10.5.86 n/w. And neither of these have a Domain Controller and none is connected to a domain. I want to Synchronise the time in two n/ws with reference to any m/c say 10.5.85.1 in the first n/w. How can that be done? If anyone of you have any idea plz do post here. And please dont advice me for any third party softwares since I am not interested in them . Right now I am using a batch file to synchronise the time in one network. I want to know how can it be spreaded to another n/w if we dont have a DC.
I use the command :
> net time \\10.5.85.1 /SET /Y
PS : I have got routers installed. So dont worry about it.
I am sorry but you realy have not given us enough information.
What type of equipment is to have time syncronisation ?
you state domains wich makes me think that you are talking about the Windows domains.
Do you have internet access ?
If the answer is that you want to use NTP on windows XP (or newer) machines and you have internet access then just point the machines towards a public NTP site. fx microsoft have one. there are several others on the internet.
If this is not the answer then please specify more parameters such as internet contact and so on.
if you are thinking of using a pc as a timeserver then I would recomend against it.
to much time slip.
since you do not want 3d party equipment i will leave that out with one small comment.
It works like a charm and I would not want to do this without it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...