Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

To make switch as a hub

I like to broadcast all the packets that is getting received on one port to all other ports.(even an unicast packet)..(you can say, i can use a HUB instead :)..but i dont have a hub now) I am using Alcatel 6850 24 X series switch. Kindly let me know, whether it is possible?..

3 REPLIES
New Member

Re: To make switch as a hub

Why on earth would you want to take a switch and turn it into a hub. You should probably just buy a hub.

hubs in a network = bad

New Member

Re: To make switch as a hub

Actually in market, i can't get a 1 Gbps hub, and i rightaway have an Alcatel's 6850 switch. Just i thought, whether i can try using this switch as hub.

Hall of Fame Super Silver

Re: To make switch as a hub

Hello Narasimhan,

the only way is to fill continuously the CAM table of the switch.

you need to perform a MAC address flooding attack using a linux PC with dsniff library installed.

I did for testing of L2 attacks but be aware that in this way you can affect the performance of the device.

It is possible but not recommended.

If you want to mirror traffic of one port to a single port where you place a sniffer you should look for port mirroring features on your switch.

Hope to help

Giuseppe

363
Views
0
Helpful
3
Replies