Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Total Output drops on switchport

I have a 3750 connected to a storage device and I am seeing alot of Total output drops on the input queue

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 76207

Queueing strategy: fifo

Output queue: 0/0 (size/max)

5 minute input rate 31734000 bits/sec, 4366 packets/sec

5 minute output rate 37218000 bits/sec, 4632 packets/sec

1784158 packets input, 1564949850 bytes, 0 no buffer

Received 1 broadcasts (0 multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

1940220 packets output, 1986930582 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

I know you can increase the hold queue but that did not help either. I am using the lastest IOS c3750-ipservicesk9-mz.122-50.SE3. Would anyone have any suggestions ?

Thanks in advance

3 REPLIES

Re: Total Output drops on switchport

In general, output drop is caused by a busty traffic pattern. You can use the command "show platform port-asic stats drop gig x/y" to see which queue is dropping the packet. And then try to adjust your queue setting by related "mls qos queue-set output" commands.

New Member

Re: Total Output drops on switchport

Thanks for the reply. Here is the output

show platform port-asic stats drop gig 1/0/1

Interface Gi1/0/1 TxQueue Drop Statistics

Queue 0

Weight 0 Frames 0

Weight 1 Frames 0

Weight 2 Frames 0

Queue 1

Weight 0 Frames 0

Weight 1 Frames 0

Weight 2 Frames 0

Queue 2

Weight 0 Frames 0

Weight 1 Frames 0

Weight 2 Frames 0

Queue 3

Weight 0 Frames 0

Weight 1 Frames 0

Weight 2 Frames 175458

sh mls qos queue-set

Queueset: 1

Queue : 1 2 3 4

----------------------------------------------

buffers : 25 25 25 25

threshold1: 100 200 100 100

threshold2: 100 200 100 100

reserved : 50 50 50 50

maximum : 400 400 400 400

Queueset: 2

Queue : 1 2 3 4

----------------------------------------------

buffers : 25 25 25 25

threshold1: 100 200 100 100

threshold2: 100 200 100 100

reserved : 50 50 50 50

maximum : 400 400 400 400

If I do sh mls-qos

QoS is disabled

QoS ip packet dscp rewrite is enabled

What be the best way to change these settings ?

Thanks

Bronze

Re: Total Output drops on switchport

Hi.

First thing is to enable QoS, as it is currently disabled:

"If I do sh mls-qos

QoS is disabled"

HTH

1130
Views
0
Helpful
3
Replies