Re: Total output drops

pchollatee · ‎08-29-2013

I found problem about "Total output drops" in interface. I aleady check bandwidth it use in 70Mbps and out 340Mbps. Capacity's port Gigabit.

Please advice me how to solve this problem.

Hardware detail

========================

Cisco 7206VXR (NPE-G1)

Cisco IOS Software, 7200 Software (C7200-JS-M), Version 12.4(25), RELEASE SOFTWARE (fc2)

Cisco 7206VXR (NPE-G1) processor (revision C) with 229376K/32768K bytes of memory.

pchollatee · ‎08-29-2013

Addition information.

Input queue: 0/75/122/1 (size/max/drops/flushes); Total output drops: 95929118

paul driver · ‎08-30-2013

Hello,

Can you show the whole inferface readout -also

sh int xx stats
sh int xx switching ( hidden command)

sh ip int xx

after that can you clear the counters on this interface-

clear counters xxx

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

pchollatee · ‎08-30-2013

Hi, pdriver

I send information to you, please advice me for solve this problem.

Thnak you.

pchollatee · ‎09-02-2013

As your request. After clear counter error still occur.

===========================================

Before clear counter

===========================================

Gi 0/2

#########################################################

Router7200#

show interfaces gigabitEthernet 0/2 stats

GigabitEthernet0/2

Switching path Pkts In Chars In Pkts Out Chars Out

Processor 7209523 923359228 5234663 440135296

Route cache 21769959690 7886764852643 25881693493 20892284926960

Total 21777169213 7887688211871 25886928156 20892725062256

Router7200#

show interfaces gigabitEthernet 0/2 switching

GigabitEthernet0/2 "to SW-vio-foundry Port10 - first"

Throttle count 0

Drops RP 1140 SP 0

SPD Flushes Fast 1 SSE 0

SPD Aggress Fast 0

SPD Priority Inputs 17527981 Drops 0

Protocol IP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 50876322 4065761287 206773753 148377551856

Cache misses 2787 - - -

Fast 110956388453 42309712030540 130932460306 103509586744379

Auton/SSE 0 0 0 0

Protocol DEC MOP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 0 0 10965 844305

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

Protocol ARP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 848695 50921568 5521022 353345408

Cache misses 0 - - -

Fast 0 0 307 19648

Auton/SSE 0 0 0 0

Protocol CDP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 1542342 547567427 110032 39280315

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

Protocol Other

Switching path Pkts In Chars In Pkts Out Chars Out

Process 2933192 1117028117 660024 39601440

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

NOTE: all counts are cumulative and reset only after a reload.

Router7200#

===========================================

Before clear counter

===========================================

Gi 0/2

#########################################################

Router7200#

show interfaces gigabitEthernet 0/2 stats

GigabitEthernet0/2

Switching path Pkts In Chars In Pkts Out Chars Out

Processor 729 89017 491 36991

Route cache 4613321 1474215837 5754494 5168029769

Total 4614050 1474304854 5754985 5168066760

Router7200#

show interfaces gigabitEthernet 0/2 switching

GigabitEthernet0/2 "to SW-vio-foundry Port10 - first"

Throttle count 0

Drops RP 1140 SP 0

SPD Flushes Fast 1 SSE 0

SPD Aggress Fast 0

SPD Priority Inputs 17528634 Drops 0

Protocol IP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 50877312 4065831708 206786739 148383515820

Cache misses 2787 - - -

Fast 110964129298 42312080539620 130942214305 103518385025490

Auton/SSE 0 0 0 0

Protocol DEC MOP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 0 0 10966 844382

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

Protocol ARP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 848767 50925888 5521168 353354752

Cache misses 0 - - -

Fast 0 0 307 19648

Auton/SSE 0 0 0 0

Protocol CDP

Switching path Pkts In Chars In Pkts Out Chars Out

Process 1542400 547588105 110036 39281743

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

Protocol Other

Switching path Pkts In Chars In Pkts Out Chars Out

Process 2933299 1117068933 660047 39602820

Cache misses 0 - - -

Fast 0 0 0 0

Auton/SSE 0 0 0 0

NOTE: all counts are cumulative and reset only after a reload.

Router7200#

show interfaces gigabitEthernet 0/2

GigabitEthernet0/2 is up, line protocol is up

Hardware is BCM1250 Internal MAC, address is 0050.0b36.b41a (bia 0050.0b36.b41a)

Description: "to SW-vio-foundry Port10 - first"

MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,

reliability 255/255, txload 74/255, rxload 20/255

Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s, media type is RJ45

output flow-control is XON, input flow-control is XON

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 00:03:25

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 28783

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 79883000 bits/sec, 32407 packets/sec

5 minute output rate 290321000 bits/sec, 40779 packets/sec

6814390 packets input, 2182125529 bytes, 0 no buffer

Received 244 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 7832 multicast, 0 pause input

0 input packets with dribble condition detected

8496755 packets output, 7539414742 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

98 unknown protocol drops

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

Router7200#

Partha Dasgupta · ‎09-03-2013

Hi,

Please provide the output of

show queueing interface gi0/2

Regards

Partha

pchollatee · ‎09-03-2013

Router7200#show queueing interface gigabitEthernet 0/2

Interface GigabitEthernet0/2 queueing strategy: none

Router7200#

paolo bevilacqua · ‎09-03-2013

What are the other interface in router, or complete config.

Also, wrong forum, post in "Small Business -". You can move your posting with the Actions panel on the right.

Joseph W. Doherty · ‎09-03-2013

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Gig port physically running at gig?

Your default egress queue, if 40, might be too small (leading to premature bust drop). Try increasing egress queue's size, you might try 512.