Of course, a firewall (if its active) would generate more traffic than a laptop to cause drops... so what u need is to try different things to figure out what solves the problem ;-) u r at the scene, we r just speculating
Enter configuration commands, one per line. End with CNTL/Z.
Switch_C2960(config)#mls qos ?
aggregate-policer Named aggregate policer
map qos map keyword
queue-set Choose a queue set for this queue
rewrite Rewrite Packet/Frame
srr-queue Configure SRR receive queues
----Other end wont support 1Gig and the traffic is not crossing more than 60Mbps
----About the Hold-queue:
Caution: An increase in the hold queue can have detrimental effects on network routing and response times. For protocols that use SEQ/ACK packets to determine round-trip times, do not increase the output queue. Dropping packets instead informs hosts to slow down transmissions to match available bandwidth. This is generally better than duplicate copies of the same packet within the network, which can happen with large hold queues.
So i need to get a down time to increase the hold queue.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.