09-11-2008 12:06 PM - edited 03-06-2019 01:19 AM
Hi all, can anyone tell me why when I traceroute through my firewall, I cannot see the ip, what do i need to enable on my asa so you can see it as a hop ?
09-11-2008 12:12 PM
Hi Carl,
By default firewall interface does not respond to ping,traceroute(icmp pkts) being security device . However, you can configure its interfaces to respond to icmp .
enable following commands:
icmp permit any outside
icmp permit any inside
HTH
Saju
Pls rate helpful posts
09-11-2008 12:26 PM
is that part of an access list or seperate commands? and why do you need to do it on the inside , does the inside not respond to ping by default, i can normally ping the inside by default
09-11-2008 12:31 PM
no they are just commands . Just input those commands when you are in config mode.
check your config , maybe its already enabled for inside interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide