I'm trying to load balacing and failover of the Internet traffic from the 2 locations, see below.
Bldg A 6509------>ASA1------->ISP
Bldg B 6509------->ASA2------->ISP
Traffic destin to the Internet will be load balancing between the buildings, traffic from users in bldg A 1st packer will hit ASA1, 2nd packet will hit ASA2. If one of the ISP down traffic will be sending to the other only. Below is the conf on both 6509's 10.20.30.1 is the inside interface of the ASA2 and 10.20.4.1 is inside interface of the ASA2. ICMP is the technic used for tracking the interfaces. I'd like to find a way of tracking the ISP not the ASA.
ip route 0.0.0.0 0.0.0.0 10.20.30.1 track 124
ip route 0.0.0.0 0.0.0.0 10.20.4.1 track 123
ip route 10.20.30.0 255.255.255.0 10.20.30.1 permanent
ip route 10.20.4.0 255.255.255.0 10.20.4.1 permanent
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.