Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Traffic Shaping

Hi guys

i am just wondering if i need a bandwidth comand under the interface that i apply shaping to or not

as we know if we normally apply a policy-map to interface and it has QoS policies we must put the amount of bandwidth if the bandwith less than the actual interface bandwith for example we have 4M from ISP ove Fa we put bandwith 4000 this will be referenced by the policy map to use the Qos incase of the interface conjested

Howver if i have this olicy map nested under another policymap that shap all the traffic to 4M when i apply the policy map with shaping i mean the parant policy in this case do i need the bandwith command or not ??

thank you

1 REPLY

Re: Traffic Shaping

If you use "bandwidth or priority" command in your policy-map, you'd better to configure a bandwidth command under the physical interface to reflect the real bandwidth.

534
Views
0
Helpful
1
Replies
CreatePlease login to create content