I have the need to switch SPAN ports from my access to a traffic concenntrador called Gigamon, however I have found that putting a single dedicated port SPAN is not enough, since the port is pulling packages, because it can not pass all traffic.
I have tried to divide the traffic into two SPAN sessiones the same switch and still not enough,
Try on Port-channel but not allowed. And the only thing left is to use the 10Gb ports to the supervisor, but these occupy for the VPC against my nexus aggregacion layer or core.
Mainly this problem as I have to switch with Supervisor CAT4500 6
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.