Transfer Config to New Switch via 'copy xmodem flash' - Many ^Z at End of File

Nickolus Looper · ‎06-27-2014

I have a config on a PC which I've obtained from switch A via:

copy run tftp

Later, I copy this file to a new switch of the same model to which I am connected via console cable via:

copy xmodem flash

(I initiate xmodem 1K send from TeraTerm)

Once the file is on the switch, I view it via:

more [filename]

It is complete, but has many ^Z characters at the end of the file.

I've had this experience various times over the last year or so using different PCs and switches.

Any ideas?

Thanks!!

paul driver · ‎06-29-2014

Hello

verify flash:xxxx.bin

res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul