Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Transfer Config to New Switch via 'copy xmodem flash' - Many ^Z at End of File

I have a config on a PC which I've obtained from switch A via:

copy run tftp

 

Later, I copy this file to a new switch of the same model to which I am connected via console cable via:

copy xmodem flash

(I initiate xmodem 1K send from TeraTerm)

 

Once the file is on the switch, I view it via:

more [filename]

 

It is complete, but has many ^Z characters at the end of the file.

I've had this experience various times over the last year or so using different PCs and switches.

Any ideas?

Thanks!!

1 REPLY

Helloverify flash:xxxx.bin

Hello

verify flash:xxxx.bin

 

res

Paul

Please don't forget to rate any posts that have been helpful. Thanks.
714
Views
0
Helpful
1
Replies
CreatePlease to create content